Unia Europejska - Europejski Fundusz Rozwoju RegionalnegoWinter Deal! | WMB products -15% | other products -10% | Valid until 31.03.2024
tel: +48 32 415 45 93
tel. kom: +48 606 228 167
tel. kom: +48 600 850 367
tel. kom: +48 602 395 202
email: wmb@wmb.pl

assembly instructions for Regipro prefabricated gypsum blocks

ASSEMBLY INSTRUCTIONS FOR PREFABRICATED GYPSUM BLOCKS

Prepare the regipro modules:

  • unpack the modules, remove the foil and protective liners, if necessary, cut the stiffened modules to the required size, you can use a regular saw to do this.
  • sand the edges of the modules using fine sandpaper.

Prepare the work area

  • mark the mounting lines,
  • place the modules against the wall and outline them
  • mark the place for fastening the mounting plates (included in the kit), remember - subtract the thickness of the gypsum board (12.5 mm) from the mounting edge (prepared outline), screw the mounting plates to the wall - for the "curtain walling" modules we use "U"-type plates (screwed from the front with a screw for plasterboard 4.5 cm), for other types of modules we use "L"-type plates, the plates should be mounted on the connections of the modules and on their length at a distance of at least one plate per each side of the development for every 2 m,
  • remember to prime the wall

Mount the modules:

  • place the prepared modules on the wall to ensure that the sheets are correctly fixed,
  • apply gypsum adhesive to the polystyrene core, point by point, every 15 cm,
  • place the module with the adhesive on the tiles, the tile should slide between the panel and the polystyrene core, press down and fit - the gypsum adhesive is flexible,
  • screw the screws on the side of the structure in the places marked earlier so that they go through the mounting plates (screws not included).

Finish the surface:

  • use fleece tape and elastic joint compound at the joint between the modules plasterboard
  • the surface of the module can be finished as you wish: paint, textured plaster, wallpaper or tiles.


Tricks & tips

Joining modules:

  • sand the joint edges with sandpaper,
  • attach mounting plates to one of the modules,
  • prime the edges of the modules,
  • apply foam adhesive to edges of modules (on polystyrene core),
  • press the modules together, align them vertically/horizontally and then screw the sheets together using plasterboard screws,
  • once the foam adhesive has dried, remove any excess with a knife and smooth out with sandpaper,
  • finish the joint with filler and lightly sand the joint once it is completely dry.

Levelling minor irregularities in the surface:

  • method 1: by extending the module on the sheet, up to a maximum of 10 mm,
  • method 2: by sanding down the edges of the module, up to a maximum of 10 mm.
+48 606 228 167
close

This site uses cookies and other tracking technologies to assist with navigation and your ability to provide feedback, analyse your use of our products and services, assist with our promotional and marketing efforts. You can find more information in "Information about the processing of personal data".